Hi everyone.
I'm trying to launch a shutdown script to an ESXi host after sensing my UPS is under 15% load.
I managed to run the action , but I get this error, "Can not read data from SSH server" in the action log , as shown in the Image1.
I set the validation SSH remote command as show in Figure 2 .
If I run this command from the server zabbix "ssh -u" it works correctly. The same if I run locally on the ESXi server.
Any idea about this issue?
Regards
Antonio.
I'm trying to launch a shutdown script to an ESXi host after sensing my UPS is under 15% load.
I managed to run the action , but I get this error, "Can not read data from SSH server" in the action log , as shown in the Image1.
I set the validation SSH remote command as show in Figure 2 .
If I run this command from the server zabbix "ssh -u" it works correctly. The same if I run locally on the ESXi server.
Any idea about this issue?
Regards
Antonio.
Attached Files