We are currently using Zabbix to monitor about 30 Cisco switchs via SNMP.
We started by using version 1.8.7 but then I started to get the SNMP error where the engine wouldn't start so I updated to 1.8.8
I'm finding that the checks are taking too long and the state of the switchs are falling into "Unknown"
If I look at my queue list I see there is about 1000 checks that fall in the 1 ~5 minutes range and sit at about 4 minutes.
Now and then it clears but just as quick as it clears it builds up again.
The computer it is running on is not under stress
Is there anything I can check to see why the Queue is building up?
Should I be logging a bug when I'm unsure if it is really a bug?
We started by using version 1.8.7 but then I started to get the SNMP error where the engine wouldn't start so I updated to 1.8.8
I'm finding that the checks are taking too long and the state of the switchs are falling into "Unknown"
If I look at my queue list I see there is about 1000 checks that fall in the 1 ~5 minutes range and sit at about 4 minutes.
Now and then it clears but just as quick as it clears it builds up again.
The computer it is running on is not under stress
Is there anything I can check to see why the Queue is building up?
Should I be logging a bug when I'm unsure if it is really a bug?