Issue with frontend in 1.1alpha2

[joe]

First off, I am very impressed by the state of this software. I am involved in a project to review Zabbix and look at the feasibility of implementation for our systems (Solaris, Linux, Cisco network hardware).

I installed 1.1alpha2 (we also have 1.0, and 1.1alpha1 installed), and I much prefer the new 1.1 frontend. It looks great.

However, I have noticed a very annoying quirk.

When adding an item, after choosing any other Type (such as SNMPv2), the page reloads and the other Items for that Host are no longer displayed. Then in order to get back to that Host, you have to choose a different host first, then go back.

I also have some other suggestions, but I'll place them in the Suggestions forum.

Again, Zabbix looks very promising!

Thanks!

joe

[Alexei]

I installed 1.1alpha2 (we also have 1.0, and 1.1alpha1 installed), and I much prefer the new 1.1 frontend. It looks great.

However, I have noticed a very annoying quirk.

When adding an item, after choosing any other Type (such as SNMPv2), the page reloads and the other Items for that Host are no longer displayed. Then in order to get back to that Host, you have to choose a different host first, then go back.

It is supposed to work this way. Do you really want to see full list of items while adding/updating an item? I believe it's more convinient to display item definition form only, without the list, which is quite long sometimes.