Distributed Monitoring: Unable to select configuration

[int13h]

I have 2 nodes (N1) and (N2). I have followed the instructions in section 14 of the Zabbix Manual to configure these systems.

N1 is the master and I can view the information on N2 from the web interface. However, when I try to view N1 from N2 I get the error: "Unable to select Configuration"

Could anyone provide a hint at what I should look at to further troubleshoot this issue?

Thanks.

[overnet]

I have the same exact problem, can someone please help with this?

[xs-]

Try selection the configuration the other way around (from N2 to N1).
The error you receive is usually gotten when you try to access a master through a slave.

[mward29]

I'm having a similar problem but after running through the distributed monitoring setup, when I hit the zabbix frontend login page, I get "Unable to select configuration."

I set nodeID=1. Made sure the zabbix services where not running and ran the conversion.

Not sure what to do at this point.