Hey all, very new to zabbix and snmp, working my way through everything. I am trying to setup a trigger for dot1dStpPortState. Essentially I want to be notified if a port on the switch goes into a blocking state (2).
At this point I am completely confused on what to do. I have SNMP builder installed. When I select BRIDGE-MIB and point it to my host I do see "dot1dStp", I can dig down into this further and see "dot1dStpPortTable". I can see in the table it is properly reporting the dot1dStpPortState for each port on the switch.
I have a feeling I need to get dot1dStpPortState to the point were it is being collected but for the life of me I can't figure it out. I would imagine once I get this going I will then be able to create a trigger based off of it. Any input or ideas on how to do this is greatly appreciated. I am trying to sift threw the documentation but its not getting me to far.
At this point I am completely confused on what to do. I have SNMP builder installed. When I select BRIDGE-MIB and point it to my host I do see "dot1dStp", I can dig down into this further and see "dot1dStpPortTable". I can see in the table it is properly reporting the dot1dStpPortState for each port on the switch.
I have a feeling I need to get dot1dStpPortState to the point were it is being collected but for the life of me I can't figure it out. I would imagine once I get this going I will then be able to create a trigger based off of it. Any input or ideas on how to do this is greatly appreciated. I am trying to sift threw the documentation but its not getting me to far.
Comment