FSNAME not displaying correct info

[scanner16]

I am new to zabbix and searched high and low for the solution to this. I am running the latest zabbix appliance, but when using the windows os template and setting the disk threshold to high the result do not show the drive letter which is low on disk space. I get @Free disk space is less than 90% on Volume /boot@ and

Free disk space is less than 90% on volume /

the only change I made was setting the % to 90 so that I can see the results.

[tcilmo]

I am new to zabbix and searched high and low for the solution to this. I am running the latest zabbix appliance, but when using the windows os template and setting the disk threshold to high the result do not show the drive letter which is low on disk space. I get @Free disk space is less than 90% on Volume /boot@ and

Free disk space is less than 90% on volume /

the only change I made was setting the % to 90 so that I can see the results.

Did things work before you made changes?

[scanner16]

no this is a new install. with everything as default.

[scanner16]

Did things work before you made changes?

I managed to resolve this issue but am presented with a new one.
solution: when creating the host although the document says it is optional. I have found that when I add the IP address of the host I get the drive letters and services among other data.

new problem: several months back I had this setup on an older appliance, where I did not need the ip address of the host, when monitoring servers outside of my network. all I needed was the agent, which would send the data to the appliance. the agents are still running on the remote servers. I have built this new appliance with the same IP address as the old one, so the agents are configured to the new appliance, there are no custom entries in the agent config file.