Image below show my list of switches.
I have same model of layer2 and layer 3 switches.
Most of them are detected by Zabbix but several are fail.
When i'm using MAP function to connect switches, the line shows that the switch is down. I use red for OFF, and blue for ON
Although the switches is detected by zabbix, the line connector show that the switch is down.
How to solve it?
I have same model of layer2 and layer 3 switches.
Most of them are detected by Zabbix but several are fail.
When i'm using MAP function to connect switches, the line shows that the switch is down. I use red for OFF, and blue for ON
Although the switches is detected by zabbix, the line connector show that the switch is down.
How to solve it?