Recovery messages doesn't work in 1.8

[ProTON]

Recovery messages doesn't work in 1.8 completely. No matter what I set I always get only original action message. Any confirmations?

UPDATE: seems like I haven't read manual carefully. Setting additional condition of Trigger value = PROBLEM helped. However there are some inconsistencies between "AND" and "AND/OR" calculation type. For example I have Trigger = mytrigger and Trigger value = PROBLEM conditions. Action has recovery messages set. With "AND/OR" calculation type I recieve 5 recovery messages, but with "AND" only 1.

[Palmertree]

I have found that the "escalations" table needs to be truncated when things go crazy... Make sure you make a backup first...

[ProTON]

I'm not using escalations and escalation table is empty.

Also this doesn't explain who AND and AND/OR calculation type differs.

[Zaniwoop]

I have the same problem.

To test it, I put "Trigger message" and "Recovery message" in message body of the two messages.

I get "Trigger Message" both times.

I am using Zabbix 1.8.1

In 1.6.x this worked fine.

[r0k5t4r]

Same Problem here. Version 1.83. Has this been fixed?

[ProTON]

It is fixed in 1.8.2. See: https://support.zabbix.com/browse/ZBX-2001

[zalex_ua]

I have the same problem.

To test it, I put "Trigger message" and "Recovery message" in message body of the two messages.

I get "Trigger Message" both times.

I am using Zabbix 1.8.1

In 1.6.x this worked fine.

Same Problem here. Version 1.83. Has this been fixed?

Maybe that's your case

https://support.zabbix.com/browse/ZBXNEXT-452

Vote if you do not want this happened on other beginners.