Hysteresis Triggers on Graphs

[vrtareg]

Hi

Previously I had a trigger configured with one condition check and it is normally were shown on the Graph.

Now when I changed it to Hysteresis Trigger with 2 conditions checks in it the Trigger the line shown on the Graph is gone.

Does anyone know is there a possibility to get it back or this is the limitation of Zabbix when using Triggers with Hysteresis?


(https://www.zabbix.com/documentation...ers/expression)

Regards,
Areg

[vrtareg]

Anyone else noticed this?

[Alexei]

The limitation has always been there. The threshold is displayed only for very simple trigger conditions.