Network interface discovery

[Joe716]

Hi guys!

I'm having trouble on network discovery.

I am using key: net.if.discovery

Filters: {#IFNAME} regex: @Network interfaces for discovery

The problem is that discovers multiple interfaces and most do not have traffic.

I would like to remove these interfaces. I need to set something in Filters? Could help me please?

[Joe716]

zabbix_get -s maq1 -k net.if.list
Ethernet enabled - WAN Miniport (IPv6)
Ethernet enabled - WAN Miniport (Network Monitor)
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server
Ethernet enabled - WAN Miniport (IP)
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server A dapter #53
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server A dapter #53-QoS Packet Scheduler-0000
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server A dapter #53-WFP LightWeight Filter-0000
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server A dapter #54
Ethernet enabled - HP NC382i DP Multifunction Gigabit Server A dapter #54-WFP LightWeight Filter-0000
Ethernet enabled - WAN Miniport (Network Monitor)-Kaspersky La b NDIS 6 Filter-0000
Ethernet enabled - WAN Miniport (Network Monitor)-QoS Packet S cheduler-0000
Ethernet enabled - WAN Miniport (IP)-Kaspersky Lab NDIS 6 Filt er-0000
Ethernet enabled - WAN Miniport (IP)-QoS Packet Scheduler-0000
Ethernet enabled - WAN Miniport (IPv6)-Kaspersky Lab NDIS 6 Fi lter-0000
Ethernet enabled - WAN Miniport (IPv6)-QoS Packet Scheduler-00 00
PPP enabled - WAN Miniport (PPPOE)
PPP enabled - RAS Async Adapter
Software Loopback enabled 127.0.0.1 Software Loopback Interface 1
Tunnel type encapsulation enabled - WAN Miniport (SSTP)
Tunnel type encapsulation enabled - WAN Miniport (IKEv2)
Tunnel type encapsulation enabled - WAN Miniport (L2TP)
Tunnel type encapsulation enabled - WAN Miniport (PPTP)

there is a way to delete the interfaces?

[oasisfy]

yes, you can use filters or regular expression in the Administration---General to
exclude the network interface you don't want to monitor

[Joe716]

yes, you can use filters or regular expression in the Administration---General to
exclude the network interface you don't want to monitor

Thanks Oasisfy, it helped a lot.

[Joe716]

I tried setting the regex, but it did not work

The setting is this? I need to set something else?

[Cynchie]

Hi,
Was the solution to this shared?

I am facing a similar issue.

Kindly advise.