Port 10050 and 10051 do not seem to be open

[funkytwig]

Hi, I was having problems connecting to a remote agent and wondered if the ports were open and run the below command and it seems 10050 and 10051 are not.

root@sun:/usr/share/zabbix/conf# nmap -v -sT localhost

Starting Nmap 6.40 ( http://nmap.org ) at 2016-06-27 23:27 BST
Initiating Connect Scan at 23:27
Scanning localhost (127.0.0.1) [1000 ports]
Discovered open port 22/tcp on 127.0.0.1
Discovered open port 111/tcp on 127.0.0.1
Discovered open port 3306/tcp on 127.0.0.1
Discovered open port 443/tcp on 127.0.0.1
Discovered open port 80/tcp on 127.0.0.1
Completed Connect Scan at 23:27, 0.01s elapsed (1000 total ports)
Nmap scan report for localhost (127.0.0.1)
Host is up (0.00021s latency).
Other addresses for localhost (not scanned): 127.0.0.1
Not shown: 995 closed ports
PORT STATE SERVICE
22/tcp open ssh
80/tcp open http
111/tcp open rpcbind
443/tcp open https
3306/tcp open mysql

Read data files from: /usr/bin/../share/nmap
Nmap done: 1 IP address (1 host up) scanned in 0.07 seconds
Raw packets sent: 0 (0B) | Rcvd: 0 (0B)

I am on Ubuntu 14.04. how do I open the ports?

Ben

[zabx_ks]

Hi funkytwig,

You can try to open 10050 port with this commad:

sudo ufw allow 10050/tcp

But you also need to be installed ufw tool on your system.

zabx_ks

[funkytwig]

I asume I need to do this on the server and client end. also do I not also need 10051 (I am using a default config).