I'm sure this is mentioned somewhere in these forums, but I was not sure what to search for. My searches did not yield any results. I apologize if this is a redundant question.
My problem is that when I site I am monitoring goes down, even for just a few seconds, the traffic graphs for interfaces stop populating (as if the site is still down) for many hours afterwards.
How do I configure Zabbix to immediately start querying for data after SNMP recovery?
Thanks!
My problem is that when I site I am monitoring goes down, even for just a few seconds, the traffic graphs for interfaces stop populating (as if the site is still down) for many hours afterwards.
How do I configure Zabbix to immediately start querying for data after SNMP recovery?
Thanks!
Comment