Network usage way out wack

[jharr]

My original installation is zabbix 1.1, and I've upgraded through 1.1.7. I have zabbix setup to monitor network tx & rx rates on all the nodes, I thought I had it setup right, but apparently not. It's off about 10,000x too high. I know I can "fix" this by setting up a multiplier, but I shouldn't have to. Here's a screen shot of my settings & what's happening.

screenshot

[Alexei]

Interesting. Did you have the same problem in 1.1?

[jharr]

yeah. I actually had a different problem then. The graphs were continually increasing (I did have delta/sec set too). I'll playing around with it a bit to see what happens.

Where would you guys suggest starting to poke around at?

[mucknet]

yeah. I actually had a different problem then. The graphs were continually increasing (I did have delta/sec set too). I'll playing around with it a bit to see what happens.

Where would you guys suggest starting to poke around at?

What about storing the value as a 64 bit Integer. It could be that you're getting the delta between two truncated results.

P.S. Make sure you clear the old data.