Issues with configuration of SNMP on Cisco Router

[jay5c]

Hello,

I am using a cisco 2911 router which I need to monitor using zabbix. I created host and applied templates but yet I am unable to bring up SNMP. It says 'timout while connecting to XX.XX.XX.XX'

Thank You

[zubrag]

Did you configure SNMP on routers?
You can test the SNMP work with "snmpwalk" or "snmpget" commands, running on zabbix site.

[scout]

Hi,

first of all, you need to setup snmp server on the router and in addition access-list (because you don't want to access SNMP on external interface of the router).
second, you need to add Cisco router as a host into the Zabbix and define template.

[jay5c]

Hi,

first of all, you need to setup snmp server on the router and in addition access-list (because you don't want to access SNMP on external interface of the router).
second, you need to add Cisco router as a host into the Zabbix and define template.

access-list 10 permit 10.0.0.0 0.255.255.255
snmp-server community (STRING) RO 10

Looks like both setup and template are already configured.
(Template SNMP Cisco Router and ZBX-Cisco_Interfaces are already configured)

What am I missing ?

Thank You

[scout]

if you would like to allow access to router's SNMP from all 10.0.0.0/24 network, then you need to use this command:

access-list 10 permit 10.0.0.0/24 (or 10.0.0.0 0.0.0.255)

Please check Cisco wildcard documentation or use wildcard calculator here: http : // www. subnet-calculator.com/wildcard.php