The list of low-level discovery rules for a template can be accessed from Configuration → Templates and then clicking on Discovery for the respective template.
The list of low-level discovery rules for a host can be accessed from Configuration → Hosts and then clicking on Discovery for the respective host.
A list of existing low-level discovery rules is displayed.
|Name||Name of the rule, displayed as a blue link.
Clicking on the rule name opens the low-level discovery rule configuration form.
If the discovery rule belongs to a template, the template name is displayed before the rule name, as a gray link. Clicking on the template link will open the rule list on the template level.
|Items||A link to the list of item prototypes is displayed.
The number of existing item prototypes is displayed in gray.
|Triggers||A link to the list of trigger prototypes is displayed.
The number of existing trigger prototypes is displayed in gray.
|Graphs||A link to the list of graph prototypes displayed.
The number of existing graph prototypes is displayed in gray.
|Hosts||A link to the list of host prototypes displayed.
The number of existing host prototypes is displayed in gray.
|Key||The item key used for discovery is displayed.|
|Interval||The frequency of performing discovery is displayed.
Note that discovery can also be performed immediately by pushing the Check now button below the list.
|Type||The item type used for discovery is displayed (Zabbix agent, SNMP agent, etc).|
|Status||Discovery rule status is displayed - Enabled, Disabled or Not supported. By clicking on the status you can change it - from Enabled to Disabled (and back); from Not supported to Disabled (and back).|
|Info||If everything is fine, no icon is displayed in this column. If there are errors, a red square icon with a cross is displayed. Move the mouse over the icon and you will see a tooltip with the error description.|
To configure a new low-level discovery rule, click on the Create discovery rule button in the top right-hand corner.
Buttons below the list offer some mass-editing options:
To use these options, mark the checkboxes before the respective discovery rules, then click on the required button.