Zabbix web service is a process that is used for communication with external web services.
This section lists parameters supported in Zabbix web service configuration file (zabbix_web_service.conf). Note that:
|AllowedIP||yes||List of comma delimited IP addresses, optionally in CIDR notation, or DNS names of Zabbix servers and Zabbix proxies.
Incoming connections will be accepted only from the hosts listed here.
If IPv6 support is enabled then
|DebugLevel||no||0-5||3||Specifies debug level:
0 - basic information about starting and stopping of Zabbix processes
1 - critical information
2 - error information
3 - warnings
4 - for debugging (produces lots of information)
5 - extended debugging (produces even more information)
|ListenPort||no||1024-32767||10053||The port service listens on for connections from the server.|
|LogFile||yes, if LogType is set to file, otherwise no||Log file name for LogType 'file' parameter.
|LogFileSize||no||0-1024||1||Maximum size of log file in MB.
0 - disable automatic log rotation.
|LogType||no||system / file / console||file||Specifies where log messages are written to:
system - syslog
file - file specified with LogFile parameter
console - standard output
|Timeout||no||1-30||3||Spend no more than Timeout seconds on processing.|
|TLSAccept||no||unencrypted / cert||unencrypted||Specifies what type of connection to use:
unencrypted - accept connections without encryption (default)
cert - accept connections with TLS and a certificate
|TLSCAFile||no||Full pathname of a file containing the top-level CA(s) certificates for peer certificate verification, used for encrypted communications between Zabbix components.|
|TLSCertFile||no||Full pathname of a file containing the service certificate or certificate chain, used for encrypted communications with Zabbix components.|
|TLSKeyFile||no||Full pathname of a file containing the service private key used for encrypted communications with Zabbix components.|