Zabbix web service is a process that is used for communication with external web services.
This section lists parameters supported in Zabbix web service configuration file (zabbix_web_service.conf). Note that:
A list of comma delimited IP addresses, optionally in CIDR notation, or DNS names of Zabbix servers and Zabbix proxies. Incoming connections will be accepted only from the hosts listed here.
If IPv6 support is enabled then
::ffff:127.0.0.1 are treated equally and
::/0 will allow any IPv4 or IPv6 address.
0.0.0.0/0 can be used to allow any IPv4 address.
Specify the debug level:
0 - basic information about starting and stopping of Zabbix processes
1 - critical information;
2 - error information;
3 - warnings;
4 - for debugging (produces lots of information);
5 - extended debugging (produces even more information).
The service will listen on this port for connections from the server.
The name of the log file.
Mandatory: Yes, if LogType is set to file; otherwise no
The maximum size of a log file in MB.
0 - disable automatic log rotation.
Note: If the log file size limit is reached and file rotation fails, for whatever reason, the existing log file is truncated and started anew.
The type of the log output:
file - write log to the file specified by LogFile parameter;
system - write log to syslog;
console - write log to standard output.
Spend no more than Timeout seconds on processing.
What incoming connections to accept:
unencrypted - accept connections without encryption (default)
cert - accept connections with TLS and a certificate
The full pathname of the file containing the top-level CA(s) certificates for peer certificate verification, used for encrypted communications between Zabbix components.
The full pathname of the file containing the service certificate or certificate chain, used for encrypted communications with Zabbix components.
The full pathname of the file containing the service private key, used for encrypted communications between Zabbix components.