In the Configuration → Discovery section users can configure and maintain discovery rules.
A listing of existing discovery rules with their details is displayed.
|Name||Name of the discovery rule. Clicking on the discovery rule name opens the discovery rule configuration form.|
|IP range||The range of IP addresses to use for network scanning is displayed.|
|Delay||The frequency of performing discovery displayed.|
|Checks||The types of checks used for discovery are displayed.|
|Status||Action status is displayed - Enabled or Disabled.
By clicking on the status you can change it.
To configure a new discovery rule, click on the Create discovery rule button in the top right-hand corner.
Buttons below the list offer some mass-editing options:
To use these options, mark the checkboxes before the respective discovery rules, then click on the required button.
As the list may contain a number of discovery rules, it may be needed to filter out the ones you really need.
The Filter link is available above the list of discovery rules. If you click on it, a filter becomes available where you can filter discovery rules by name and status.