In the Configuration → Discovery section users can configure and maintain discovery rules.
A listing of existing discovery rules with their details is displayed.
|Name||Name of the discovery rule. Clicking on the discovery rule name opens the discovery rule configuration form.|
|IP range||The range of IP addresses to use for network scanning is displayed.|
|Delay||The frequency of performing discovery displayed.|
|Checks||The types of checks used for discovery are displayed.|
|Status||Action status is displayed - Enabled or Disabled.
By clicking on the status you can change it.
To configure a new discovery rule, click on the Create discovery rule button in the top right-hand corner.
Buttons below the list offer some mass-editing options:
To use these options, mark the checkboxes before the respective discovery rules, then click on the required button.