manual:introduction:whatsnew420

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
manual:introduction:whatsnew420 [2019/04/03 12:28]
martins-v some rewording
manual:introduction:whatsnew420 [2021/11/13 16:59] (current)
Line 130: Line 130:
  
 ^Version^LLD data flow^ ^Version^LLD data flow^
-|Before Zabbix 4.2  |//​Discovery rule// ​-> //Discovery rule filter// ​ | +|Before Zabbix 4.2  |//​Discovery rule// ​→ //Discovery rule filter// ​ | 
-|In Zabbix 4.2  |//​Discovery rule// ​-> //​Preprocessing// ​-> //Custom macros// ​-> //Discovery rule filter// ​ |+|In Zabbix 4.2  |//​Discovery rule// ​→ //​Preprocessing// ​→ //Custom macros// ​→ //Discovery rule filter// ​ |
  
 It's important to understand that this logic works in the order from left to right, the same as when defining the rule: first the discovery happens, then optionally preprocessing is applied to it, then custom macros may be extracted and then the filter conditions are applied to the result. It's important to understand that this logic works in the order from left to right, the same as when defining the rule: first the discovery happens, then optionally preprocessing is applied to it, then custom macros may be extracted and then the filter conditions are applied to the result.
Line 224: Line 224:
 {{:​manual:​introduction:​html_messages.png|}} {{:​manual:​introduction:​html_messages.png|}}
  
-HTML format can be selected in the //Message format// option when configuring email as the media type in //​Administration// ​-> //Media types//.+HTML format can be selected in the //Message format// option when configuring email as the media type in //​Administration// ​→ //Media types//.
  
 ==== Testing media types ==== ==== Testing media types ====
Line 325: Line 325:
 === Sender uses all ServerActive addresses === === Sender uses all ServerActive addresses ===
  
-Zabbix sender now uses all addresses defined in the agent ServerActive configuration parameter for sending data, instead of the first entry only. If sending to one address fails, the sender tries sending to the other addresses. If sending of batch data fails to one address, ​other batches are not sent to this address. ​+Zabbix sender now uses all addresses defined in the agent ServerActive configuration parameter for sending data, instead of the first entry only. If sending to one address fails, the sender tries sending to the other addresses. If sending of batch data fails to one address, ​the following ​batches are not sent to this address. ​
  
 ==== See also ==== ==== See also ====
  
   * [[:​manual/​installation/​template_changes|Template changes]]   * [[:​manual/​installation/​template_changes|Template changes]]