While generally problem events are resolved automatically when trigger status goes from 'Problem' to 'OK', there may be cases when it is difficult to determine if a problem has been resolved by means of a trigger expression. In such cases, the problem needs to be resolved manually.
For example, syslog may report that some kernel parameters need to be tuned for optimal performance. In this case the issue is reported to Linux administrators, they fix it and then close the problem manually.
Problems can be closed manually only for triggers with the Allow manual close option enabled.
When a problem is “manually closed”, Zabbix generates a new internal task for Zabbix server. Then the task manager process executes this task and generates an OK event, therefore closing problem event.
A manually closed problem does not mean that the underlying trigger will never go into a 'Problem' state again. When new data arrive for any item included in the trigger expression, the whole expression is re-evaluated and may result in a problem again.
Two steps are required to close a problem manually.
If a problem arises for a trigger with the Manual close flag, you can go to the acknowledgement screen of that trigger and close the problem manually.
To close the problem, check the Close problem option in acknowledgement form and click on Acknowledge.
The request is processed by Zabbix server. Normally it will take a few seconds to close the problem. During that process CLOSING is displayed in Monitoring → Problems as the status of the problem.
It can be verified that a problem has been closed manually: