manual:appliance

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
manual:appliance [2020/05/21 04:40]
marinagen [ZBX-17749] System requirements
manual:appliance [2020/05/21 10:15]
yuriii [7.2 HDD/flash image (raw)] replaced 5.0 with 5.2
Line 7: Line 7:
 Zabbix appliance and installation CD versions are based upon the following OS:  Zabbix appliance and installation CD versions are based upon the following OS: 
 ^Zabbix appliance version^OS^ ^Zabbix appliance version^OS^
-|5.0.0|CentOS 8  |+|5.0.0|CentOS 8 (x86_64) ​ |
  
 Zabbix appliance installation CD can be used for instant deployment of Zabbix server (MySQL). Zabbix appliance installation CD can be used for instant deployment of Zabbix server (MySQL).
  
 == System requirements:​ == == System requirements:​ ==
-  * //Disk space//: at least 8 GB should be allocated for the virtual machine+  ​* //RAM//: 1.5 GB 
-  * //​Architecture//:​ only x86_64 is supported. +  ​* //Disk space//: at least 8 GB should be allocated for the virtual machine.
  
 |{{:​manual:​installation_cd_boot_menu1.png?​600|}}| |{{:​manual:​installation_cd_boot_menu1.png?​600|}}|
Line 32: Line 31:
  
 To get started, boot the appliance and point a browser at the IP the appliance has received over DHCP.  To get started, boot the appliance and point a browser at the IP the appliance has received over DHCP. 
 +
 +<note important>​ DHCP must be enabled on the host. </​note>​
  
 To get the IP address from inside the virtual machine run: To get the IP address from inside the virtual machine run:
Line 48: Line 49:
   [zabbix]   [zabbix]
   name=Zabbix Official Repository - $basearch   name=Zabbix Official Repository - $basearch
-  baseurl=http://​repo.zabbix.com/​zabbix/​4.5/​rhel/​8/​$basearch/​+  baseurl=http://​repo.zabbix.com/​zabbix/​5.2/​rhel/​8/​$basearch/​
   enabled=1   enabled=1
   gpgcheck=1   gpgcheck=1
Line 160: Line 161:
 == - HDD/flash image (raw) == == - HDD/flash image (raw) ==
  
-  dd if=./​zabbix_appliance_5.0.0.raw of=/dev/sdc bs=4k conv=fdatasync+  dd if=./​zabbix_appliance_5.2.0.raw of=/dev/sdc bs=4k conv=fdatasync
   ​   ​
 Replace ///​dev/​sdc//​ with your Flash/HDD disk device. Replace ///​dev/​sdc//​ with your Flash/HDD disk device.